Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in

R stamp requirements

Status
Not open for further replies.
fhw

fhw

Mechanical
Nov 8, 2015
4
0
0
SA
Hi all,

If the Stainless Steel bolts of a U-stamped Heat exchanger body flange (Channel-tubesheet-shell) are going to be replaced with Carbon Steel bolts, would that need R stamp on the Heat exchanger?

Thanks
 
Status
Not open for further replies.

Similar threads

cyrus2000_
  • Locked
  • Question
Relaible China CNC machining shop recommend 1
Replies
2
Views
9
looslib
looslib
CarlosGarza10
  • Locked
  • Question
Is it possible to calculate punts using RPMs in an extruder
Replies
0
Views
11
CarlosGarza10
CarlosGarza10
Ramadan Ahmed
  • Locked
  • Question
Width of an O-Ring Groove to an Edge 7
Replies
13
Views
14
mfgenggear
mfgenggear
Tobias_CS
  • Locked
  • Question
High Grip Rubber?
Replies
2
Views
4
dik
dik
tarekzad
  • Locked
  • Question
Belt Conveyor Rule of Thumb Specific energy (kWh/t.km) 2
Replies
13
Views
32
LittleInch
LittleInch
Back
Top