Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

R14 questions

Status
Not open for further replies.

pedromorgan

Mechanical
Jul 23, 2006
14
GB
Is it possible to measure the length of a curved line on autocad 14?

If there are several curves can I join them together and measure the length of the whole line rather than measuring each of the curves in turn?

I have a drawing of a door that I want to import as a block into another drawing of a house where it will be used several times. Is it possible to do it so that if I make a change to the first drawing it will show up on all the blocks in the second?

Thanks in advance

Peter Morgan
 
Replies continue below

Recommended for you

Yes. Make it a pline and then LIST it.

if the curves meet end to end, you can convert them to a pline and then LIST it. otherwise you will have to add up each "piece".

You can XREF the item in the other drawings to have it update. Otherwise you would have to insert it again into the other dwgs and have it update the others on insertion.

"Everybody is ignorant, only on different subjects." — Will Rogers
 
Won't Listing the properties of an Arc give curve length in R14? I don't remember, but it does in 2005.

Here's one from a boundary plat I just did, and it is exactly the same length as it is when converted to pline:
Command: list
1 found
ARC Layer: "swt metes"
Space: Model space
Handle = e635
center point, X=2261055.1289 Y=197865.5278 Z= 0.0000
radius 260.0000
start angle N 17d44'15" W
end angle N 49d52'27" W
length 145.8317

Engineering is the practice of the art of science - Steve
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top