Radius maching with short length ballnose EM

[neeruk]

HI all

I am using 5axis horizontal machining ceneter (X,Y,Z,B,A) to cut a fillet arround the boss with short lenth ball nose endmill.In this case to avoid gouging on the part all 5 axis (X,Y,Z,B,A) should move am I rite.I tried with mult multiaxis variable contour and contour profile but I failed.
Can any one give an idea?
I attached a simple sample part file can you go through that.
file is in nx 7.5
thanks and regards
neeru

 

[wmalan]

Can't read the part (at home) but... sounds like Contour Profile or SeqMill if that fails from what I'm reading.

--
Bill

 

[neeruk]

HI Bill

you can fix Xo Yo Z0 A0 B0 at any where. Just I want use short lenth endmill

Thx and Regards

 

[wmalan]

In Variable Contour there is a field for setting the tools lean away from the drive surface to keep shank/holder clear.

--
Bill

 

[wmalan]

In Variable Contour Profile there is a field for setting the tools lean away from the drive surface to keep shank/holder clear.

--
Bill

 

[neeruk]

Hi

Thax Bill, I did with contour profile/streamline .