hi everyone, duno if there's an already existing similar thread, but however...
my question is: what's the right technique to design a spiral ramp/staircase in rhino 4?
i mean, first of all, how to set the right curves in the right way? and then, which commands are better than others to obtain the simpliest object as possible?
im not a complete n00b, i can handle pretty well basic commands, btw.
and i have sketches of that, if needed.
could someone give a helping hand? thx
my question is: what's the right technique to design a spiral ramp/staircase in rhino 4?
i mean, first of all, how to set the right curves in the right way? and then, which commands are better than others to obtain the simpliest object as possible?
im not a complete n00b, i can handle pretty well basic commands, btw.
and i have sketches of that, if needed.
could someone give a helping hand? thx
