Random model view changes

[mrvnmrshun]

I'm having a problem that is random when looking at a sketch or model of a part. The view will move all by itself. I can click on the top view button and let it sit in that oriention and at random intervals the view will shift out of that oriention by a few degrees. Has anyone seen this type of problem before?

 

[PDMAdmin]

I've seen that happen with the "zoom" function using a web wheel mouse. Have you verified that it's not an issue with your mouse, or perhaps a sticky keyboard?

 

[mrvnmrshun]

I'm not so sure that it could be the mouse or keyboard, because it will do this when i'm not even touching the mouse or keyboard.

 

[PDMAdmin]

Understood, but if the mouse or keyboard is "sticky," you won't need to be touching it. Sometimes when I roll my web wheel on the mouse, it will keep zooming out in the SW view, even though I'm not touching the mouse anymore.

 

[ewh]

I've seen this happen with optical mice on mousepads that have a lot of white in their design. If this is the case, simply use a different pad (or none at all).

 

[ewh]

I've also seen this with wired mice. Adjust the mouse sensitivity, and it should go away.

 

[mrvnmrshun]

Thanks for the suggestion ewh. I was using a light gray mousepad. Now that I stopped using that mousepad it hasen't happened.