Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

RCC-M : RMC 2410

Status
Not open for further replies.
R4FKEN

R4FKEN

Nuclear
Mar 15, 2016
14
RMC 2410 states that only straight probes are allowed for UT of thicknesses over 60 mm. A colleague of mine is convinced that this implicates the plates have to be scanned from both surfaces, because of the dead zone of straight probes. It's impossible for me to change his mind: i believe this dead zone has been considered during writing of RMC 2410 and, as a result, scanning from one side is sufficient. Anyone with experience with this paragraph?
 
Status
Not open for further replies.

Similar threads

matschka
  • Locked
  • Question
New Nuclear: Russia reaches milestone with Kursk II RPV
Replies
0
Views
429
matschka
matschka
patmohr
  • Locked
  • Question
MCSA Implementation
Replies
1
Views
397
Strong
Strong
sleepingSatellite
  • Locked
  • Question
Burn-up unit of measure
Replies
3
Views
489
Kwan
Kwan
DSMyles
  • Locked
  • Question
Storage of Flammable and Hazardous Materials in Reactor Containment 2
Replies
1
Views
93
racookpe1978
racookpe1978
DNitzsche
  • Locked
  • Question
ASME III sub ND Buterfly 6" seat valve material
Replies
3
Views
92
DNitzsche
DNitzsche

Part and Inventory Search

Sponsor

Back
Top Bottom