Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Re-Ordering Drafting Sheets 1
- Thread starter Ciderman
- Start date
-
1
- #2
Ciderman,
You should be able to use cut paste in the drawing navigator at the side of the screen. If you had 3 sheets they'd be shown as Sheet.1 Sheet.2 Sheet.3 in that order. If you wanted to place sheet 2 after sheet 3 you could select sheet.2 and Cut it with Ctrl+X or RMB Cut then you can select Drawing and hit Ctrl+V to paste the cut sheet. Then the pasted sheet would be put last in the list.
Michael
![[swords]](/data/assets/smilies/swords.gif "[swords] [swords]")
You should be able to use cut paste in the drawing navigator at the side of the screen. If you had 3 sheets they'd be shown as Sheet.1 Sheet.2 Sheet.3 in that order. If you wanted to place sheet 2 after sheet 3 you could select sheet.2 and Cut it with Ctrl+X or RMB Cut then you can select Drawing and hit Ctrl+V to paste the cut sheet. Then the pasted sheet would be put last in the list.
Michael
- Status