Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Read-Only

Thread starter DieMan44
Start date Jul 1, 2005

Status: Not open for further replies.

Jul 1, 2005

DieMan44

Mechanical

I added a part family member as a componet to my design. However, I wish to alter the part slighty and add a couple of reference sets. This part family is from a company that manufactures lifter assemblies and has a complicated spread sheet in that master part file that I do not wish to alter. I tried doing a "save as"m, but it did not work. Is there some way to "save" the part as an editable file?

Jeff