Realize Shape 1

[CAD2015]

I have seen in Siemens PLM Community > NX Design > NX Design Knowledge Base > All TKB Articles in NX Design Knowledge Base
a short demonstration about "Realize Shape" ( by Sam Kuan )

Subject: NX Quick Tips - NX 9 Realize Shape - ( 9 hours ago )
Subdivision modeling offers you both speed and ease when you design a product. Push and pull command).

I was looking to find "Realize Shape" in NX 9, but I couldn't find it!
Could somebody direct my search in this ,matter?
Thanks!

P.S. This is the link:

http://community.plm.automation.sie...st-type/thread/board-id/NXDesignKnowledgeBase

MZ7DYJ

 

[PhoeNX]

Try using the command finder and you will need a license to use Realize Shape.

Anthony Galante
Senior Support Engineer


NX3 to NX10 with almost every MR (21versions)

 

[CAD2015]

The command "finder" couldn't find Realize Shape........

MZ7DYJ

 

[PhoeNX]

What version of NX9? You need to have NX9.0.1 installed. It wasn't added until the NX9.0.1 Maintenance Release was added.

Anthony Galante
Senior Support Engineer


NX3 to NX10 with almost every MR (21versions)

 

[CAD2015]

Oh, I believe that I have NX 9.0.......It makes sens......
Thanks

MZ7DYJ