Reassociation of surface finish symbols in NX7

[eex23]

Is it possible to reassociate surface finish symbols in NX7? What I need to do, then this associativity is already lost (eg, I added a chamfer to an edge) ?

Thanks
Nx7.0.1.7 mp2
win xp 32 bit +sp3

 

[JohnRBaker]

It can be done in NX 7.5.

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.org/museum/

To an Engineer, the glass is twice as big as it needs to be.

 

[eex23]

hrrrr