Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recognize sheetmetal object

Thread starter abeschneider
Start date May 28, 2006

Status: Not open for further replies.

May 28, 2006

abeschneider

Mechanical

I'm having trouble using the "Recognize" tool in Catia V5R16. I have an extruded part of uniform thickness which consists of two tangential circular bends. (There is no "flat" straight section on the part, other than the thin sides.)

I haven't been able to figure out how to take this part and "Recognize" it as a Generative Sheet Metal part.

Any tips?
Thanks.