Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recommend a plasma cutter table

Status
Not open for further replies.

tharding247365

Mechanical
Dec 30, 2014
39
Looking for a plasma cutter to cut 3mm aluminum panels. Looking for high resolution accurate cuts.

Anybody have recommendations on a plasma cutter table? Want to use one with a hypertherm cutter.

A fiber laser would probably more suitable for this but they're too expensive.
 
Replies continue below

Recommended for you

Status
Not open for further replies.

Part and Inventory Search

Sponsor