Rectangular Array 1

[Judge]

Hi. I've recently began using UG NX 7.5 & I could do with some help in creating a rectangular array. Problem is, the parameters are only for XC & YC, whereas I would like to array along ZC. Any suggestions would be much appreciated. Please note, I'm an absolute beginner.
Thank you.
Judge.

 

[cubalibre000]

Double click on the wcs and change provisionary the x or y direction to obtain the z direction and then you are able to make the pattern.
Re-establish the wcs as before.
Other solution is switch to NX 8.

Thank you...

Using NX 8 and TC8.3

 

[cubalibre000]

have you tried 'pattern face' ?

Thank you...

Using NX 8 and TC8.3

 

[Judge]

Thanks Cubalibre00. Changing the WCS worked perfectly.

I haven't used pattern face before, but I'll investigate further.

Thank you
Judge.