Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Rectangular HSS beam to Round HSS column connection 1

Status
Not open for further replies.

cmrdata

Structural
Oct 19, 2010
70
I appreciate any comments or suggestions you might have on the rectangular HSS to round HSS connection detail shown in the attached sketch.
Thanks.
 
Replies continue below

Recommended for you

I think I would add a knife plate stiffener at the centerline of the column extending into the supporting HSS tube that flared top and bottom from the far edge of the square HSS section to the inside face of the round HSS section. Seems better for the bending moment than just relying on the side walls of both sections.

Mike McCann
MMC Engineering
 
Which is the load side, the round column (which I think is the support being a column) or the rectangular girder, or are both tied to each other?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor