Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Reduced beam model for an assembly

Status
Not open for further replies.

NaikD

Mechanical
Nov 23, 2002
48
Hi All,

I need help with general guide lines to create a beam model for a complex assembly that would match at least first few frequencies.

For known cross sections (angle, channel etc.,) I can build the model. However, for complex assemblies with many subassemblies, I am assuming the process could be of a trial and error by assuming simplified cross sections and adjusting density to match first couple of frequencies (say 5).

Any help is appreciated.

Thanks,
- Dipak
 
Replies continue below

Recommended for you

You are not limited to these common cross-sections only. You can draw a complex user defined section and the software will calculate its properties. Or select user integrated section and enter the geometry data obtained somewhere else.

If your model is too complicated for beams but has thin-walled members then consider using shell elements. Modal analysis should solve relatively fast even for large models.
 
Thank you FEA way!

I never had to build a reduced beam model to represent a complex assembly so wanted to learn from the experts here.

Yes my model is too complicated with steel and aluminum alloy parts. I can build a model with shell elements. However, customer wanted a reduced beam element model so shell model is not an option.

I can approximate a complex user defined section to represent the assembly. I thought to match first few frequencies I will have to play with density/modulus of elasticity.

Thanks again. I appreciate your help!

- Dipak
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor