patelam
Civil/Environmental
- Jan 27, 2022
- 36
I am trying to reduce the gage at MC 12x40 to 1.75in for a 5/8" A325 bolt. The workable gage is 2.5".
How can I verify that the washers and nuts at the bolt holes will not overlap fillet radius of MC? Does maintaining clearance for tightening (C1) as given in Table 7-15 of AISC Steel Handbook ensures that the washers will not overlap? If not, how do I find the fillet radius of MC 12x40?
Please provide your suggestions.
Thank you in advance.
How can I verify that the washers and nuts at the bolt holes will not overlap fillet radius of MC? Does maintaining clearance for tightening (C1) as given in Table 7-15 of AISC Steel Handbook ensures that the washers will not overlap? If not, how do I find the fillet radius of MC 12x40?
Please provide your suggestions.
Thank you in advance.