Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Referance sets

Status
Not open for further replies.

flitch1969

Automotive
Jan 3, 2014
19
When i create features they get added to the referance sets. i would prefer to add them myself. Where is the setting to stop this from happening?

thanks
 
Replies continue below

Recommended for you

You can find this in the Customer Defaults under Assemblies - Site Standards - Tab Reference Sets - Model Reference Set.

Set it to No Automation. (this can be blocked by your site admin)


Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2

Building new PLM environment from Scratch using NX11 / TC11
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor