Reference Dimension

[Recon1775]

I haven't used AutoCad for a few years and I remember when drawing lines or any feature there used to be a dimension that would show referencing a endpoint or any reference near by as you draw the feature. I'm currently using AutoCad LT 2004... I'm I losing my mind or is there something like this?

 

[borgunit]

Not sure about LT but could you be referring to OSNAP or maybe OTRACK? At the bottom of the AutoCAD screen are a series of buttons that you can toggle on. OSNAP and OTRACK are two of them. Does LT have this?

"Everybody is ignorant, only on different subjects." — Will Rogers