Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in

Reflector panel surface tolerance

Status
Not open for further replies.
rapper

rapper

Mechanical
Mar 18, 2003
3
0
0
GB
Does anybody know the appropriate 'profile of surface' tolerance to achieve a surface accuracy of 0.25mm RMS.
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Status
Not open for further replies.

Similar threads

Gehr
  • Locked
  • Question
Waveguide Internal Surface Roughness 1
Replies
5
Views
6
MacGyverS2000
MacGyverS2000
FMeyer
  • Locked
  • Question
Cross-pol component in offset reflector geometry
Replies
2
Views
3
VEBill
VEBill
kurtulmehtap
  • Locked
  • Question
Large Parabolic Panel Reflectors for 10 Ghz EME
Replies
3
Views
4
Higgler
Higgler
blueandwhiteg3
  • Locked
  • Question
Dual-reflector system on a parabolic for many feeds
Replies
0
Views
1
blueandwhiteg3
blueandwhiteg3
msucog
  • Locked
  • Question
surface wave antenna
Replies
6
Views
8
VEBill
VEBill
Back
Top