Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Remote machine room disconnect

Status
Not open for further replies.
mvsubstation

mvsubstation

Electrical
Joined
Aug 5, 2003
Messages
34
Location
US
The door to the machine room is not visible from where the motor controllers are (you must walk to the end of a hallway, turn left and then go up some stairs to another level where the controllers are located). Are two disconnects required? One near the door and another within site of the motor controller?
 
Sort by date Sort by votes
This was recently discussed. Check out:
thread242-117363

David Baird
mrbaird@hotmail.com

Sr Controls Engineer

EET degree.

Journeyman Electrician.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

VVhope
  • Locked
  • Question Question
Residual pressure at most remote connection on standpipe system if the building is sprinklered
Replies
5
Views
1K
skdesigner
skdesigner
SA07
  • Locked
  • Question Question
To install sprinklers in a turbo-alternator room
Replies
0
Views
203
SA07
SA07
engggu
  • Locked
  • Question Question
IDF CABINET/ROOM
Replies
1
Views
398
MGXFP
MGXFP
Corey Rao
  • Locked
  • Question Question
does a UPS room need a Clean agent protection as per NFPA?
Replies
3
Views
825
FacEngrPE
FacEngrPE
engggu
  • Locked
  • Question Question
Cross Main pipe passing thru Server Room
Replies
4
Views
316
cdafd
cdafd

Part and Inventory Search

Sponsor

Back
Top