6060842
Mechanical
- Jan 1, 2008
- 27
Hello all new to this forum
I have a question about the remote mass facility in cosmos. I have used ANSYS previously which had a facility called point mass. When this was positioned, it was shown in the preview as a ball, showing the cog of the mass at its xyz co-ordinates.
I have tried the remote mass facility in cosmos and it does not show within the preview. It certainly is being allowed for in the calculation, but just not visible in the model preview.
If i apply a moment instead of a mass, this shows in the preview just fine
Any body have any ideas?>
Tom
I have a question about the remote mass facility in cosmos. I have used ANSYS previously which had a facility called point mass. When this was positioned, it was shown in the preview as a ball, showing the cog of the mass at its xyz co-ordinates.
I have tried the remote mass facility in cosmos and it does not show within the preview. It certainly is being allowed for in the calculation, but just not visible in the model preview.
If i apply a moment instead of a mass, this shows in the preview just fine
Any body have any ideas?>
Tom