Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

removing blips on the printout of a drawing

Status
Not open for further replies.

Guest
Does anyone know if it is possible not to print the blips in a solidworks 2D drawing. With blips i mean the centermarks of the arcs.
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Status
Not open for further replies.

Similar threads

CAD2015
  • Locked
  • Question
Rotate a view in the direction of a line.................. 3
Replies
17
Views
30
jassco
jassco
33MRM33
  • Locked
  • Question
SW Macro to list hole wizard features and measures the diamter of modeled hole
Replies
4
Views
41
Gupta65
Gupta65
Chocolate_chimmy
  • Locked
  • Question
Issue:Solidworks Drawing Edge Selection
Replies
4
Views
20
jassco
jassco
Platypusimon
  • Locked
  • Question
calculating the mass & volume of section of a part/assembly model in solidworks
Replies
10
Views
42
jassco
jassco
jassco
  • Question
Solidworks VBA to GET and SET dimensions on a sketch in an assembly model
Replies
1
Views
38
jassco
jassco
Back
Top