Removing Drawing Templates from Teamcenter Unified 8.3

[backwoodsbob]

We had a PAX file that was not correct. I fixed and now there is 4 Drawing templates that I can't seem to get rid of. Anybody know how to get rid of them.

Thanks,
Bob

 

[Toost]

Get rid , - How , -from where ? ( Teamcenter or not ?)

Regards,
Tomas

 

[backwoodsbob]

After running the nxdm_ugs_drawing_templates.pax with <RelationType>model</RelationType> for each drawing templae an then fixing it and running it with <RelationType>specification</RelationType> the drawing show up correctly now, but I have the old "model" templates that I can't get rid of. when I go into NX from Teamcenter and do a File New and select Drawing I can't get rid of the "master" files. See attachment.

 

[Toost]

Make sure that there is only this "pax file" where the file name starts with "nxdm_*.pax".
All "nxdm_*.pax" will be read by NX at startup ( in managed mode)

2:nd question, do your pax file contain more sections like:

<PaletteEntry id="d1">
<References/>
<Presentation name="A - Drawing" description="NX Example, 2 Sheets">
<PreviewImage type="UGPart" location="@DB/A-drawing-template/A"/>
</Presentation>
<ObjectData class="DrawingTemplate">
<TemplateFileType>none</TemplateFileType>
<Filename>@DB/A-drawing-template/A</Filename>
<Units>English</Units>
<UsesMasterModel>Yes</UsesMasterModel>
<ItemType>Item</ItemType>
<RelationType>specification</RelationType>
</ObjectData>
</PaletteEntry>

than needed for the desired 4 templates ?
- Delete.

If the above doesn't help,
The NX syslog reports which paxfiles it read on startup and each line ( above section) where / how etc.

Regards,
Tomas

 

[SDETERS]

Do you have your PAX files in Teamcenter?

 

[backwoodsbob]

Tomas,

I got rid of the extra pax files and that seemed to fix it. I don't see the other files in Drawing now.

Thanks a lot for the help.

Bob