Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Removing explode lines in detail view in drawing

Thread starter Simon205
Start date Aug 10, 2011

Status: Not open for further replies.

Aug 10, 2011

Simon205

Mechanical

Hi Guys,

I have an exploded view of an assembly in a SW drawing. I've created a detail view of an area of this view, but can't work out how to hide the explode lines in the detail view.

I can't work out how to put them ona separate layer, or hide them in the detail view.

Any ideas?