Hi all,
This is happening in an assembly drawing. I needed to change the name of the configuration of a part. The part (with the specific configuration) was previously #4 in the BOM (the BOM had 12 items). After renaming the part configuration, it appeared in the BOM as #13 and #4 was missing from the list (1-2-3-5-6...13).
Question: how can I renumber the parts so that the sequence of the BOM is continuous with no numbers missing (1-12)?
Thank you,
Sorin
This is happening in an assembly drawing. I needed to change the name of the configuration of a part. The part (with the specific configuration) was previously #4 in the BOM (the BOM had 12 items). After renaming the part configuration, it appeared in the BOM as #13 and #4 was missing from the list (1-2-3-5-6...13).
Question: how can I renumber the parts so that the sequence of the BOM is continuous with no numbers missing (1-12)?
Thank you,
Sorin