Tofflemire
Marine/Ocean
- Oct 3, 2002
- 312
Hi All
I hope I'm not asking a questions that has already been asked. My questions are as follows.
1. I want to be able to set the height of each row that is created by the repeat region, the way I see it working now is what ever the driver repeat row height is, this set all the row heights, can I create a varible to set each row height???
2. I'm importing an assembly from Orcad (Printed Circut Board Assembly), It gives me Reference Designators for each resistor, capacitors etc... I can show these in Assembly mode, but where I need to show them is on the Assembly Drawing, but I can not seem to be able to turn these on to show.
Question 2 is Driving question 1 because one or more components may have more than 1 line worth of Reference Designators to show in the Repeat Region. I do not want my repeat region to grow horizontally out of control
Thanks for any help
Tofflemire
I hope I'm not asking a questions that has already been asked. My questions are as follows.
1. I want to be able to set the height of each row that is created by the repeat region, the way I see it working now is what ever the driver repeat row height is, this set all the row heights, can I create a varible to set each row height???
2. I'm importing an assembly from Orcad (Printed Circut Board Assembly), It gives me Reference Designators for each resistor, capacitors etc... I can show these in Assembly mode, but where I need to show them is on the Assembly Drawing, but I can not seem to be able to turn these on to show.
Question 2 is Driving question 1 because one or more components may have more than 1 line worth of Reference Designators to show in the Repeat Region. I do not want my repeat region to grow horizontally out of control
Thanks for any help
Tofflemire