Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in

replace return bends by headers in furnace?

Status
Not open for further replies.
SukhpalSingh

SukhpalSingh

Petroleum
May 19, 2016
25
0
0
IQ
Is that possible to replace the return bends in a furnace that is worked in Vacuum unit by headers did API 560 permits this replacement?
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Status
Not open for further replies.

Similar threads

tankinspector88
  • Locked
  • Question
Weldability of a API-650 tank constructed in 1980 3
Replies
5
Views
13
FacEngrPE
FacEngrPE
myname_earl
  • Locked
  • Question
API 510 - In-Service, Out-of-Service Clarification 1
Replies
2
Views
15
myname_earl
myname_earl
WissamH
  • Locked
  • Question
Guidelines for Selecting the Freeboard in Ground Storage Tanks 4
Replies
16
Views
58
WissamH
WissamH
jfacevedob
  • Locked
  • Question
Diameter limitation for SS anchor bolt in API 650 tanks 1
Replies
2
Views
15
IFRs
IFRs
MATEGRITY2009
  • Locked
  • Question
In-service flare tip inspection 2
Replies
2
Views
4
Louisiana Inspector
Louisiana Inspector
Back
Top