Requirements for an N-Stamp?

[packdad]

In order to have a Section III component N-stamped, does it require that both the design and fabrication be done by an N certificate holder (as opposed to just the fabrication)? That's been my understanding, but I've forgotten the basis. I'm off to go flip through the Code, but I thought I'd post this here as well.

 

[packdad]

I guess I posted in haste. NA-3310 specifically states that an N certificate holder is responsible for the design.

 

[lostsailor]

packdad,
responsibilites of the owner and N certficate holder are set forth in ASME III part NCA. For your question look at NCA-3200 and NCA-3500.
Regards,
RLS