Restart analysis_ CSYS_transformation_written_out

[kemom]

Hi there,

I am using the restart command in abaqus so as to run only a single step of my sim. The problem that I came across is that I cannot write out CSYS transformations in my inp file. For instance, I select a new node set to apply a load on it as a respect to a newly_defined (or pre-defined) CSYS cylindrical system and when I apply the load it seems that the load is in respect to the default CSYS. I am looking for something relevant in the manual but I cannot find anything I am afraid. Could anyone give me any advice please?

Thanks a lot in advance

Kemom