Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Revert Frame Generation

Thread starter cbinder
Start date Jan 25, 2019

Status: Not open for further replies.

Jan 25, 2019

cbinder

Structural

I was given an inventor model with a large and complex frame structure that was made with the frame generator built into Inventor. My question is, how do I revert that back to wireframe, single lines and nodes, so I can end up getting a workable DXF to import into RISA 3D?

Thanks