Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Reviewing run-times after analysis

Status
Not open for further replies.
DanJordy

DanJordy

Mechanical
Jun 14, 2005
16
When I run an analysis, then save and close ANSYS, is there any way to resume that .db/results file to find out how long the analysis ran for?
 
Status
Not open for further replies.

Similar threads

Anatoly_k
  • Question
Pipe Burst Pressure - elastic-plastic analysis strange asymmetry
Replies
0
Views
576
Anatoly_k
Anatoly_k
H
  • Question
Plasticity behaviour is not being computed in a non-linear analysis in ANSYS Mechanical APDL 2024 r2
Replies
0
Views
1K
hmsilva
H
Faraz1997
  • Locked
  • Question
How to reduce number of iterations in tabular data of transient thermal analysis
Replies
3
Views
454
NRP99
NRP99
LIAM_7
  • Locked
  • Question
ANSYS and fatigue analysis
Replies
0
Views
182
LIAM_7
LIAM_7
andradesilva
  • Locked
  • Question
modal analysis in ANSYS Mechanical APDL 2020 R2: How to see graphical results without mesh/elements
Replies
1
Views
445
NRP99
NRP99

Part and Inventory Search

Sponsor

Back
Top Bottom