Revision problem

[JJL79]

All our parts are always created with Revision _ and first time a revision occurs it should start from A. If by mistake a part is created with Revision A, is it possible somehow to change this to _ without getting problems when if a revision occurs it changes back to A?

NX 6, Teamcenter

 

[JHTH]

We use a utility from Siemens called 'Recursive Rename' (contact Siemens or your reseller and ask about it). If/when you have it, select the Item Rev in TC and run the Rename utility. This will let you change the Revision value to anything you like.

HTH

Jon

JHTH
NX 7.0.1.7 + TC 2007

 

[JHTH]

Any news on this?

JHTH
NX 7.0.1.7 + TC 2007

 

[JJL79]

Sorry i did not reply earlier. I have not contacted our reseller about this. I will wait until we really have to change the Revision value and keep "Recursive Rename" in mind until then.

Thank you for your help!