Revision Schemes and EPDM

[SWUSER71]

How can I set up the workflow in EPDM to use a numeric revision scheme, then upon choice, start using an alpha numeric scheme?

 

[kellnerp]

This may be something to take up with your VARs AE. Judging by the dearth of responses, there aren't a lot of people trained in EPDM on this forum. You might also try asking on [link swcad@googlegroups.com]SWCAD][/url] as I know Dan Bovinich had the training.

TOP
CSWP, BSSE

http://www.engtran.com

http://www.niswug.org

http://www.linkedin.com/in/engineeringtransport

Phenom IIx6 1100T = 8GB = FX1400 = XP64SP2 = SW2009SP3
"Node news is good news."

 

[Badwolf]

You need to set up revision number components and revision numbers to suit the schemes that you want to use. The only way that i can think of to switch is to have a workflow state that incorporates a change of revision scheme as part of the transition to it.

Hope this helps