Revision Table Template with Revision 00 filled out 2

[RachelYork]

The company I work with uses Revision 00 to 'Release for manufacturing'. I'd like to create a SolidWorks BOM Template with this included as it is standard. When I fill out the revision row and save to a template file, the save excludes the revision 00. Is there a way to save a BOM template with the first revision already filled in?
Thanks!

 

[CorBlimeyLimey]

"I'd like to create a SolidWorks BOM Template with this included as it is standard."

"Is there a way to save a BOM template with the first revision already filled in?"

I assume you meant Rev and not BOM

... and to answer your question, No.

 

[ctopher]

You can add the rev table to your drawing template, add the row with the revision, then save back the drawing template.
I have mine setup this way.

Chris
SolidWorks 10 SP4.0
ctopher's home
SolidWorks Legion

 

[RachelYork]

Thank you Chris! I think this will work for us.

 

[CorBlimeyLimey]

Chris ... With the rev showing? When I tried it didn't show.

Will try again later.

 

[ctopher]

CBL,
Yes.
Open the template, add the rev block and the rev.
"Save sheet format" and also do a "save as .drwdot".

Chris
SolidWorks 10 SP4.0
ctopher's home
SolidWorks Legion

 

[CorBlimeyLimey]

Hmmm ... Worked this time. Must have been a hiccup ... or I did something stupid.

Anyway, good to know.