Apparently we have tools that operate at 13.6 mhz and 2.54 ghz and I've been asked if we need to add RF & MW guidelines to our electrical safety policy. All the emmissions are supposed stay inside the tools but we have technicians that check boards and subassemblies that have busses with those frequencies. OSHA &IEEE literature I've googled seems to be more concerned with transmission fields. Anything else I should look into?
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
RF & MW power guidelines
- Thread starter caporter
- Start date
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question