Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Rising Stem Globe Valve Style Seal

Status
Not open for further replies.

MattB

Mechanical
Nov 14, 2001
4
US
I am tasked with designing a globe valve style seat seal with the following parameters:

150 PSI Max. Pressure
400 F Max. Temp
Fluids to be sealed are steam and or water.

Is there a good resource available which could show me acceptable geometries (angles, finishes, etc...) and seal materials, as well as compression forces required for the seals so that I may size the actuators as well.

All responses are appreciated.

Matt
 
Replies continue below

Recommended for you

Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top