Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

rms 1

Status
Not open for further replies.
rhinohorn

rhinohorn

Petroleum
Oct 3, 2001
2
Could someone tell me what "RMS" stands for as it applies to surface roughness.
 
Replies continue below

Recommended for you

Sort by date Sort by votes
RMS: Root Mean Square. This is one of the standard methods used to calculate surface roughness. RMS is measured in either micro-inches or micro-meters. A low measurement indicates a smooth, high-quality surface finish. Other methods of calculating surface roughness include Ra (Arithmetic Mean Roughness) and Rt (Maximum Peak-to-Valley Roughness Height).

Ref. from
 
Upvote 0 Downvote
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top Bottom