Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Robot for shell design?

Thread starter charliealphabravo
Start date May 7, 2012

Status: Not open for further replies.

May 7, 2012

charliealphabravo

Structural

Has anyone used Robot for shell design/analysis?

We are reviewing software for tank design and since Etank2000 will not do conical bottom tanks we are looking at FEM packages.

We'd like to select a single FEM package that will also do conventional frame and plate design so if Robot is suitable for tank design it would help.

Thanks in advance.