Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
rods manufacturing method (except putrusion)
- Thread starter carbongr
- Start date
carbongr (Materials)
A lot depends on the quantities you need.
A method for small batch work, is to wet preg the roving, draw it through a sizing die to control the resin content, then lay the strands in a mold, close the mold and cure.
A cruder method is to wet the strands on a board, tension wrap them around two pins, then wrap the roving bundles with heat shrink tape, then cure. Leave enough excess to cut off the ends.
B.E.
A lot depends on the quantities you need.
A method for small batch work, is to wet preg the roving, draw it through a sizing die to control the resin content, then lay the strands in a mold, close the mold and cure.
A cruder method is to wet the strands on a board, tension wrap them around two pins, then wrap the roving bundles with heat shrink tape, then cure. Leave enough excess to cut off the ends.
B.E.
- Status
Similar threads
- Locked
- Question