Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Roll forming 1" Bronze?

Status
Not open for further replies.
sprintcar

sprintcar

Mechanical
Oct 16, 2001
763
Anyone have experience in roll forming Bronze (Alum-Bronze type alloy)- section about 1" square - into rings? I know thin brass forms well but haven't tryed thick sections. Also need a source
Thanks!

Keep the wheels on the ground
Bob
showshine@aol.com
 
Status
Not open for further replies.

Similar threads

enginesrus
  • Question
What brass or bronze for water couplings?
Replies
9
Views
5K
Brooke William
B
David Maijala
  • Locked
  • Question
Cold forming AL alloy in W or AQ condition 2
Replies
4
Views
135
MagBen
MagBen
just_some_shmuck
  • Locked
  • Question
Steel mill terminology: "weld repair" - Do mills repair defects?
Replies
6
Views
235
Ng2020
Ng2020
b_unruhly
  • Locked
  • Question
1215 Hot Rolled vs Cold Rolled
Replies
19
Views
431
mfgenggear
mfgenggear
rideHPD
  • Locked
  • Question
1/4, 1/2 Hard 316 Sheet, Availability/Experience?
Replies
8
Views
381
TugboatEng
TugboatEng

Part and Inventory Search

Sponsor

Back
Top Bottom