GaborHun
Mechanical
- May 27, 2008
- 16
I try to convert to sheet metal something similar to the attached picture, but had no luck with it yet.
I have no idea about what method shall I use. I'd say something around "sketched bend" might do the trick, but playing with the parameters did not give any solution. I start to wonder if it is feasible at all or not.
Any help would be appreciated. I use SW 2007.
I have no idea about what method shall I use. I'd say something around "sketched bend" might do the trick, but playing with the parameters did not give any solution. I start to wonder if it is feasible at all or not.
Any help would be appreciated. I use SW 2007.