I'm trying to model two rolls in 2D rolling contact. So far I haven't been able to rotate the rolls because the elements I have used (Plane82, Plane183) only have 2 degrees of freedom (UX,UY). Is it possible to construct some kind of rolling contact in 2D? Should I use a different type of element? The problem is a plane strain problem.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
rolling contact problem in Ansys
- Thread starter aajii
- Start date
- Status
Similar threads
- Locked
- Question
- Locked