Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Roof Maintenance Question?

Status
Not open for further replies.

Antnyt23

Structural
Jul 11, 2012
81
For roof maintenance if a parapet is not constructed to be 39" or greater is the maintenance worker required to use fall protection due to it being a walking working surface that is considered unprotected?
 
Replies continue below

Recommended for you

When less than 6-ft of the 'edge' tie-off is mandatory. I would interpret the 'edge' to be either the outer edge or centerline of the parapet. I could defend my choice of 'centerline' easier than 'edge' when in an OSHA audit.

Low parapet equals 'no protection' in OSHA.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor