Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

rotary swith,leadwell manual

Thread starter grinderguy
Start date Oct 22, 2003

Status: Not open for further replies.

Oct 22, 2003

grinderguy

Mechanical

Can anyone tell me where to get a manual and electrical diagram for a Leadwell ltc-15 turning center. Controller is fanuc ot. The component with a problem is the rotary switch on the turret shaft. Tool position 8 does not happen. I suspect one pair of wires is disconnected. I can not read the mfg on the switch. It is type HS-04008FAP2. SN 04348 24VAC.

Robert Setree

http://www.advanced-grinding.com