Agriego
Mechanical
- Nov 7, 2003
- 85
Good morning,
I am working on a series of isometric explosion drawings. I've done one explosion in the default isometric view, but now I need to do an explosion from the opposite side of the model. I've tried using the arrow keys and <shift> arrow keys, but that's not helping. I need to rotate the view about the Y axis and then save the new view. How do I do that? It was a no brainer in NX, but I'm at my wits end here. I'm about ready to chuck this POS software out the window.![[banghead] [banghead] [banghead]](/data/assets/smilies/banghead.gif)
Al
I am working on a series of isometric explosion drawings. I've done one explosion in the default isometric view, but now I need to do an explosion from the opposite side of the model. I've tried using the arrow keys and <shift> arrow keys, but that's not helping. I need to rotate the view about the Y axis and then save the new view. How do I do that? It was a no brainer in NX, but I'm at my wits end here. I'm about ready to chuck this POS software out the window.
![[banghead] [banghead] [banghead]](/data/assets/smilies/banghead.gif)
Al