Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IFRs on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Rotating Postviews

Thread starter bcotten2
Start date Aug 24, 2012

Status: Not open for further replies.

Aug 24, 2012

bcotten2

Aerospace

Hello,

I'm using NX 8 to perform a Thermal Analysis using the Space Systems Thermal Advanced Simulation module. All of a sudden I am not able to rotate my model in the post views (ie. the results views). When I try to rotate the cue line reads "Unable to rotate specified view".

Any help solving this issue would be greatly appriciated.

Thanks,

Brad