mcpille
Automotive
- Jan 10, 2011
- 2
Hi,
I'm having big problems to create a rotationally symmetric mesh in Icem 12.1.
I've meshed the disc with an ogrid. The edges are perfectly quadratic. I've defined the edge parameters with each 4 nodes and "mesh law" uniform.
Thogh the nodes aren't distributed equally along the curves. The distance between the nodes differs a little bit (e.g. 0.0158 and 0.0154).
Can somebody help me?
I'm having big problems to create a rotationally symmetric mesh in Icem 12.1.
I've meshed the disc with an ogrid. The edges are perfectly quadratic. I've defined the edge parameters with each 4 nodes and "mesh law" uniform.
Thogh the nodes aren't distributed equally along the curves. The distance between the nodes differs a little bit (e.g. 0.0158 and 0.0154).
Can somebody help me?