Round in Wildfire Sheetmetal

[antran7]

For the life of me, I can't figure out how to add a round to a sheetmetal part in Wildfire.

In 2001, you could add a solid round to a sheetmetal edge. For example, if you had a flat square sheetmetal part. You can round the 4 edges to make a flat rounded square sheetmetal part.

I had to resort to making a sheetmetal cut in Wildfire. This can't be the way.

Any ideas? Thanks

 

[antran7]

well. i found it. it's not under the menu picks, but it's under the "insert" tool bar.