Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations The Obturator on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Routing - Changing The Default Min Bend Radius

Thread starter Nicole6022
Start date Apr 27, 2010

Status: Not open for further replies.

Apr 27, 2010

Nicole6022

Aerospace

I would like to specify a value for the minimum radius my spline can have, without having to go through the effort of defining a custom library. Is there not a way I can just select a spline and define the bend radius I would not like it to go under?

Thank You in Advance,
Nicole