Do you guys know where the table here: comes from? I haven't seen much allowance/calculation for butt/fillet welds in bending about its weak axis...
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
Roymech Weld Stress table
- Thread starter 1980c3
- Start date
at the link it says :
"The methods described below is based on the simple method of calculation of weld stress as identified in BS 5950- clause 6.7.8.2 . The other method identifed in BS 5950 - 1 clause 6.7.8.3 as the direction method uses the method of resolving the forces transmitted by unit thickness welds per unit length into traverse forces (FT ) and longitudinal forces (FL ). "
"The methods described below is based on the simple method of calculation of weld stress as identified in BS 5950- clause 6.7.8.2 . The other method identifed in BS 5950 - 1 clause 6.7.8.3 as the direction method uses the method of resolving the forces transmitted by unit thickness welds per unit length into traverse forces (FT ) and longitudinal forces (FL ). "
- Status
Similar threads
- Locked
- Question
- Locked
- Question